Installation desktop

From STX Linux Wiki

[edit] Version 1

• 1.At “boot:” prompt press Enter
• 2.At language selection prompt press Enter
• 3.Type root then press Enter
• 4.Type cfdisk then press Enter
• 5.At “Do you wish to start with zero table?” press Y
• 6.Press right (“New” is highlighted) then press Enter
• 7.(“Primary” is selected) press Enter
• 8.Type the size of your hard disk drive in megabytes (1 gigabyte = 1000 megabytes) less 100 then press Enter
• 9.(“Beginning” is selected) press Enter
• 10.Press right until Bootable is selected then press Enter
• 11.Press down then press Enter
• 12.Press Enter
• 13.Press Enter
• 14.Press right until “Type” is selected then press Enter
• 15.Press a key to continue
• 16.If 82 is not entered, type it then press Enter
• 17.Press right until “Write” is selected then press Enter
• 18.Type yes then press Enter
• 19.Press right until “Quit” is selected then press Enter
• 20.Type setup then press Enter
• 21.Press down (“ADDSWAP” is selected) then press Enter
• 22.Press Enter
• 23.Press Enter
• 24.Press right (“No” is selected) then press Enter
• 25.Press Enter for the next 8 options
• 26.Wait 5 minutes
• 27.Press Enter for the next 4 options
• 28.Press right (“No” is selected) then press Enter
• 29.Press Enter
• 30.Press down until “EXIT” is selected then press Enter
• 31.Remove CD then reboot the PC